Changing the water filter in your Viking refrigerator is an essential maintenance task that helps ensure the water you and your family consume is clean and safe. Over time, the filter can become clogged with impurities, reducing its effectiveness. Therefore, it is crucial to know how to change the Viking refrigerator water filter correctly. In this step-by-step guide, we will walk you through the process and provide you with all the information you need to get the job done easily.
Gather the Materials
Before starting the process of changing the water filter, it is essential to gather all the necessary materials. You will need:
- A new Viking refrigerator water filter
- A bucket or towels to catch any water that may drip
- A clean cloth or sponge
- A pen or sticker to mark the date of filter installation
Locate the Water Filter
The next step is to locate the water filter inside your Viking refrigerator. The filter is typically located in the upper right corner of the refrigerator compartment, either in the ceiling or back corner. Some Viking refrigerators have a filter cover, while others have a filter housing. Refer to your owner’s manual for the exact location of the water filter in your specific model.
Step 1: Turn Off the Water Supply
Before removing the water filter, it is crucial to turn off the water supply. Look for the shut-off valve located behind the refrigerator or underneath your kitchen sink. Turn the valve clockwise to shut off the water supply, ensuring no water flows into the refrigerator during the filter change process.
Step 2: Remove the Water Filter
If your Viking refrigerator has a filter cover, detach it by pressing the release latch and pulling the cover down. For models with a filter housing, twist the filter housing counterclockwise until it unlocks. Gently pull the filter housing or cover away from its compartment to expose the filter. In some cases, you may need to remove a cap or seal from the filter before being able to pull it out.
Step 3: Dispose of the Old Filter
Once you have removed the filter from the housing or cover, dispose of it properly. Wrap it in a plastic bag or place it in a sealed container to prevent any potential contamination. It is worth noting that some water filters may be recyclable, so you may want to check with your local recycling center regarding proper disposal methods.
Step 4: Prepare the New Filter
Before installing the new water filter, it is crucial to prepare it correctly. If your new filter comes with a cap or seal, remove it carefully. Thoroughly rinse the filter under cold water for approximately 15 seconds to remove any residual carbon dust. This step helps ensure optimal performance and taste of the filtered water.
Step 5: Install the New Filter
Now that the new filter is ready, it’s time to install it. Align the filter correctly with the filter housing or cover and push it into place. If your Viking refrigerator has a filter housing, twist it clockwise until it locks into position. For models with a filter cover, push it upward until it clicks or snaps back into place.
Step 6: Reset the Filter Indicator
After installing the new water filter, it is necessary to reset the filter indicator light to ensure accurate monitoring of the filter’s lifespan. Refer to your owner’s manual for specific instructions on how to reset the filter indicator, as the process may vary depending on the model.
Step 7: Turn On the Water Supply and Test
Once the new filter is installed and the indicator is reset, it’s time to turn on the water supply. Locate the shut-off valve and turn it counterclockwise to allow water flow into the refrigerator again. Afterward, run a few cups of water through the dispenser to flush out any air or impurities that may have accumulated during the filter change process. Dispose of this initial water, and then enjoy fresh, clean water from your Viking refrigerator.
Conclusion
Changing the water filter in your Viking refrigerator is a relatively simple process that can have a significant impact on the cleanliness and quality of the water you consume. By following the step-by-step guide outlined above, you can easily replace the water filter and ensure optimal filtration performance. Remember to refer to your owner’s manual for specific instructions and to purchase the correct replacement filter for your Viking refrigerator model. Regularly changing the water filter will help ensure the health and well-being of you and your loved ones.