Refrigerators have become an essential part of our daily lives, helping us keep our food fresh and cool. The Kenmore refrigerator is one of the most popular brands in the market, known for its reliability and durability. However, just like any other appliance, there may come a time when a part needs to be replaced or repaired. One common issue that arises is a faulty light switch in the refrigerator. In this article, we will guide you through easy steps on how to replace a Kenmore refrigerator light switch.
Gather the necessary tools and materials
Before you begin the process of replacing the light switch, it is important to gather all the necessary tools and materials. This will help ensure a smooth and efficient replacement process. Here’s what you’ll need:
– Replacement light switch
First and foremost, you will need to purchase a replacement light switch for your Kenmore refrigerator. You can find these at hardware stores or order them online. Make sure to get the correct model and size for your specific refrigerator.
– Screwdriver
A screwdriver is an essential tool for any DIY project. In this case, you will need a screwdriver to remove the screws that hold the light switch in place.
– Wire cutter/stripper
A wire cutter/stripper is necessary to cut and strip the wires connected to the old light switch. This will allow you to safely disconnect the old switch and connect the new one.
Unplug the refrigerator and locate the light switch
Safety should always be your top priority when working with any electrical appliance. Start by unplugging the Kenmore refrigerator from the power source to avoid any accidents. Once unplugged, open the refrigerator door and locate the light switch. The light switch is typically located near the top of the refrigerator compartment.
Remove the light switch cover and disconnect the wires
In order to replace the faulty light switch, you will need to remove its cover first. Use the screwdriver to carefully remove the screws that hold the light switch cover in place. Once removed, gently pull out the cover to expose the wires and the switch.
Take a moment to carefully observe how the wires are connected to the old switch. This will help you later when connecting the new switch. Using the wire cutter/stripper, remove the wires from the old switch by cutting or stripping the insulation. Make sure to keep track of which wire is connected to which terminal on the old switch.
Replace the old light switch with the new one
Now that the old light switch has been disconnected and removed, it’s time to install the new one. Take the replacement light switch and connect the wires you removed from the old switch to the corresponding terminals on the new switch. Make sure to securely tighten the terminals to ensure a proper connection.
After connecting the wires, carefully place the new switch into the designated slot and ensure it is flush against the refrigerator wall. Use the screwdriver to fasten the switch in place by tightening the screws.
Test the new light switch
Once the new light switch is securely in place, it’s time to test it out. Plug the refrigerator back into the power source and close the refrigerator door. The light switch should now be operational, and the light inside the refrigerator should turn on when the door is opened.
If the light does not turn on, double-check the connection of the wires to the new switch. Ensure they are properly connected and tightened. If the issue persists, it may be best to consult a professional for further assistance.
Conclusion
Replacing a Kenmore refrigerator light switch is a relatively simple task that can be done by most individuals with basic DIY skills. By following these easy steps, you can successfully replace a faulty light switch and restore the functionality of your refrigerator’s light. Remember to always prioritize safety when working with electrical appliances and consult a professional if needed.